TM 9-2320-361-20 CHAPTER 2 SERVICE AND TROUBLESHOOTING INSTRUCTIONS Section I. Repair Parts, Special Tools, TMDE, and Support Equipment (page 2-1) Section II. Service Upon Receipt (page 2-1) Section III. Preventive Maintenance Checks and Services (PMCS) (page 2-2) Section IV. Mechanical Systems Troubleshooting (page 2-24) Section V. Compressed Air and Brake System Troubleshooting (page 2-52) Section VI. Electrical Systems Troubleshooting (page 2-74) Section VII. STE/ICE Troubleshooting (page 2-148) Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT 2-1. COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE) applicable to your unit. 2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT Special Tools, Special Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment used to maintain the vehicles covered in this manual can be found in TM 9-2320-361-20P. 2-3. REPAIR PARTS Repair parts covering unit maintenance are listed and illustrated in the Repair Parts and Special Tools List (TM 9-2320-361-20P). Section Il. SERVICE UPON RECEIPT 2-4. GENERAL a. Upon receipt of a new, used, or reconditioned vehicle, you must determine if the vehicle has been properly prepared for service. The following steps should be performed: (1) Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working order. (2) Secure, clean, lubricate, or adjust as needed. (3) Check all Basic Issue Items (TM 9-2320-361-10) to be sure every item is present, in good condition, and properly mounted or stowed. (4) Follow general procedures for all service and inspections given in TM 9-2320-361-10. b. The operator will assist when performing service upon receipt inspections. c. Refer to TM 9-2320-361-10 when testing equipment for proper operation. 2-5. GENERAL INSPECTION AND SERVICING INSTRUCTIONS The following steps should be taken while performing general inspection and services: (1) Use TM 9-2320-361-10 and LO 9-2320-209-12-1, as well as other sections of this manual, when servicing and inspecting equipment. 2-1