TM 9-2320-361-20 12-15. DUMP BODY FRONT SPLASH GUARD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) M342A2 TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Twelve locknuts EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). 1. Remove two locknuts (1), screws (7), and brace (8) from front splash guard (6), support (5), and frame (2). Discard locknuts (1). NOTE If replacing right side front splash guard, remove braces from fuel tank bracket. 2. Remove four locknuts (11), screws (10), and two braces (9) from front splash guard (6) and air reservoir bracket (12). Discard locknuts (11). 3. Remove three locknuts (1), screws (7), and front splash guard (6) from support (5). Discard locknuts (1). 4. Remove three locknuts (3), screws (4), and support (5) from frame (2). Discard locknuts (3). b. Installation 1. Install support (5) on frame (2) with three screws (4) and new locknuts (3). 2. Install front splash guard (6) on support (5) with three screws (7) and new locknuts (1). NOTE If replacing right side front splash guard, braces are installed on fuel tank bracket. 3. Install two braces (9) on front splash guard (6) and air reservoir bracket (12) with four screws (10) and new locknuts (11). 4. Install brace (8) on front splash guard (6) and frame (2) with two screws (7) and new locknuts (1). 12-20