TM 9-2320-361-20 12-6. FRONT SPLASH GUARD REPLACEMENT (M35A2C, M36A2) This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) M35A2C, M36A2 TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Ten locknuts EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). NOTE Left and right front splash guards are removed the same. This procedure covers the left front splash guard. a. Removal 1. Remove two locknuts (13) and screws (8) from splash guard braces (6) and front splash guard (14). Discard locknuts (13). 2. Remove two locknuts (4), screws (5), and splash guard braces (6) from frame (2). Discard locknuts (4). NOTE Perform step 3 only if pioneer tool kit is on vehicle. 3. Remove two locknuts (15) and screws (7) from front splash guard (14) and pioneer tool kit bracket (1). Discard locknuts (15). 4. Remove two locknuts (3), screws (16), and splash guard (14) from frame (2). Discard locknuts (3). NOTE Perform step 5 for M35A2C vehicles. 5. Remove two locknuts (9), screws (12), plate (10), and bumper (11) from front splash guard (14). Discard locknuts (9). b. Installation 1. 2. 3. 4. 5. 12-8 NOTE Perform step 1 for M35A2C vehicles. Install bumper (11) and plate (10) on front splash guard (14) with two screws (12) and new locknuts (9). Install front splash guard (14) on frame (2) with two screws (16) and new locknuts (3). NOTE Perform step 3 only if pioneer tool kit is installed on vehicle. Install front splash guard (14) on pioneer tool kit bracket (1) with two screws (7) and new locknuts (15). Install two splash guard braces (6) on frame (2) with two screws (5) and new locknuts (4). Install two splash guard braces (6) on front splash guard (14) with screws (8) and new locknut (13).