TM 9-2320-361-20 11-41. PERSONNEL HEATER CONTROL CABLES REPLACEMENT This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS Four lockwashers TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). 1. Loosen screw (6) and remove cable (7) from shaft (5) and clamp (4) on diverter (3). 2. Loosen screw (16) and remove cable (8) from shaft (18) and clamp (19) on adapter (17). 3. Remove two nuts (1), lockwashers (2), screws (10), and bracket (9) from instrument panel (15). Discard lockwashers (2). 4. Remove nut (13), lockwasher (11), and cable (8) from bracket (9). Discard lockwasher (11). 5. Remove nut (14), lockwasher (12), and cable (7) from bracket (9). Discard lockwasher (12). b. Installation 1. Install cable (7) in bracket (9) with new lockwasher (12) and nut (14). 2. Install cable (8) in bracket (9) with new lockwasher (11) and nut (13). 3. Install bracket (9) to instrument panel (15) with two screws (10), new lockwashers (2), and nuts (1). 4. Insert cable (8) through clamp (19) and install on shaft (18) of adapter (17). 5. Insert cable (7) through clamp (4) and install on shaft (5) of diverter (3). 1. Loosen screw (16) and slide cable (8) through clamp (19). 2. Push shaft (18) of adapter (17) forward and tighten screw (16). 3. Loosen screw (6) and slide cable (7) through clamp (4). 4. Push shaft (5) of diverter (3) to the right, and tighten screw (6). 11-78