TM 9-2320-361-20 11-35. WINDSHIELD WASHER RESERVOIR, TUBING, JET, AND PUMP REPLACEMENT This task covers: a. Windshield Washer Reservoir Removal e. Windshield Washer Pump Installation b. Windshield Washer Tubing Removal f. Windshield Washer Jet Installation c. Windshield Washer Jet Removal g. Windshield Washer Tubing Installation d. Windshield Washer Pump Removal h. Windshield Washer Reservoir Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS Four locknuts TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). a. Windshield Washer Reservoir Removal 1. Remove cover (17) with grommet (16) from reservoir (19). Remove strainer (18) from hose (7) and hose (7) from grommet (16) and cover (17). 2. Remove three locknuts (24), two clamps (23), plate (22), two screws (21), washers (20), and reservoir (19) from steering column (25). Discard locknuts (24). b. Windshield Washer Tubing Removal 1. 2. 3. NOTE Tag hose and tubes for installation. Disconnect tubes (4), (6), and (28) from valve (29). Disconnect hose (7) and tubes (6) and (9) from tee connector (8). Remove grommet (27) and hose (7) from dash panel (26). c. Windshield Washer Jet Removal Remove nut (5), washer (2), and jet (3) from cowling (1). d. Windshield Washer Pump Removal Remove locknut (10), washer (11), windshield washer pump (13), washer (14), and screw (15) from instrument panel (12). Discard locknut (10). e. Windshield Washer Pump Installation Install windshield washer pump (13) on instrument panel (12) with washer (14), screw (15), washer (11), and new locknut (10). I f. Windshield Washer Jet Installation Install washer (2) and jet (3) on cowling (1) with nut (5). 11-70