TM 9-2320-361-20 11-33. WINDSHIELD WIPER MOTOR AIR TUBES REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P Air reservoir drained (TM 9-2320-361-10). a. Removal 1. Compress two clamps (4) and remove hose (13) from copper tube (3) and fitting (12). 2. Remove three screws (1) and clamps (2) from windshield outer frame (8). Compress clamp (4) and remove copper tube (3) from hose (5). 3. Compress three clamps (4) and remove hoses (5), (6), and (10) from tee (11). 4. Remove screw (1) and clamp (9) from windshield outer frame (8). Compress two clamps (4) and remove hoses (10) and (6) from windshield wiper motors (7). b. Installation 1. Compress two clamps (4) and install hoses (10) and (6) on windshield wiper motors (7). Install clamp (9) on hose (6) and windshield outer frame (8) with screw (1). 2. Compress three clamps (4) and install hoses (5), (6), and (10) on tee (11). 3. Compress clamps (4) and install copper tube (3) on hose (5). Install three clamps (2) on copper tube (3) and windshield outer frame (8) with three screws (1). 4. Compress two clamps (4) and install hose (13) on copper tube (3) and fitting (12). FOLLOW-ON TASK: Start engine, check for leaks (TM 9-2320-361-10). 11-67