TM 9-2320-361-20 11-30. FRONT FENDERS MAINTENANCE This task covers: a. Removal c. Installation b. Inspection and Repair INITIAL SETUP: APPLICABLE MODELS All MATERIALS/PARTS Four screw-assembled lockwashers Thirteen locknuts Anti-squeak material Adhesive (Appendix C, Item 1) REFERENCES (TM) TB 43-0213 TC 9-510 TM 9-237 TM 9-2320-361-10 EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). Front wheels removed (TM 9-2320-361-10). Side panel removed (para. 11-11). Front composite lamp housing and brackets removed (para. 4-41). Personnel hot water heater removed (left side only) (para. 11-42). Exhaust system removed (right side only) (para. 3-37 or 3-38). Airhorn removed (right side only) (para. 4-31). Turn signal flasher removed (left side only) (para. 4-20). TM 9-2320-361-20P NOTE Right and left fenders are replaced the same. This procedure covers right side. 1. Remove two screws (30), locknuts (28), clamps (29), and wiring harness (25) from fender support (21). Discard locknuts (28). 2. Remove three screw-assembled lockwashers (16) from fender (13) and cowl (4). Discard screw- assembled lockwashers (16). 3. Remove three locknuts (22), screws (26), fender mount springs (27), and nine washers (23) from fender (13) and fender support (21). Discard locknuts (22). 4. Remove two locknuts (12), screws (7), and washers (6) from light support bracket (10) and fender (13). Discard locknuts (12). 5. Remove three locknuts (11), washers (9), screws (8), and washers (9) from fender (13) and light support bracket (10). Discard locknuts (11). 6. Remove screw-assembled lockwasher (19), locknut (14), screw (17), and brace (18) from flame (5). Discard screw-assembled lockwasher (19) and locknut (14). NOTE Assistant will help with step 1. 7. Remove two locknuts (3), screws (15), washers (2), fender (13), and fender mount spacer (24) from fender support (21), bracket (20), cowl (4), and light support bracket (10). Discard locknuts (3). 8. Remove anti-squeak material (1) from cowl (4). Discard anti-squeak material (1). 11-52