TM 9-2320-361-20 11-21. WINDSHIELD ARM, GLASS, AND HANDLE REPLACEMENT This task covers: a. Arm RemovaI d. Handle Installation b. Glass Removal e. Glass Installation c. Handle Removal f. Arm Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS Nine screw-assembled lockwashers Three seals Bumper Adhesive (Appendix C, Item 3) TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Wiper motors removed (para. 11-34). a. Arm Removal Remove two screws (8) and spring washers (9) from arm (11), outer frame bracket (5), lever (12), and glass frame bracket (10). b. Glass Removal 1. Remove seven screw-assembled lockwashers (18) from windshield hinge (3) and windshield outer frame (4). Discard screw-assembled lockwashers (18). 2. Remove two hinge seals (1) and (2) from windshield hinge (3). Remove seal (13) from windshield inner frame (19). Discard seals (1), (2), and (13). c. Handle Removal 1. Remove two screws (17), nuts (15), and handle (14) from windshield inner frame (19). 2. Remove bumper (16) from handle (14). Discard bumper (16). 3. Remove two screw-assembled lockwashers (6) and plate (7) from windshield outer frame (4). Discard screw-assembled lockwashers (6). d. Handle Installation 1. Install new bumper (16) in handle (14). 2. Install handle (14) on windshield inner frame (19) with two screws (17) and nuts (15). 3. Install plate (7) on windshield outer frame (4) with two new screw-assembled lockwashers (6). 11-34