TM-9-2320-361-20 Page 727

TM-9-2320-361-20 Unit Maintenance Manual for M44A2 Series Trucks

Page 727 of 1207

TM 9-2320-361-20 11-20. WINDSHIELD ASSEMBLY MAINTENANCE This task covers: b. Disassembly a. Removal c. Assembly d. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Three lockwashers EQUIPMENT CONDITION Two locknuts Eighteen screw-assembled lockwashers Parking brake set (TM 9-2320-361-10). Three weatherstrips Soft top removed (TM 9-2320-361-10). Adhesive (Appendix C, Item 2) Wiper motors removed (para. 11-34). a. Removal 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. NOTE Perform steps 1 through 3 for vehicles equipped with hardtop kit. Remove two screws (8) and lockwashers (7) from cab hardtop (6) and windshield frame (5). lockwashers (7). Remove two screws (2), washers (3), and locknuts (4) from cab hardtop (6) and windshield frame (5). Discard locknuts (4). Loosen two knobs (11). NOTE Two lower hinges are attached to cab by six screw-assembled lockwashers. Exhaust support is attached to lower right hinge and cab by a longer screw and lockwasher. Assistant will help with step 4. Discard Remove six screw-assembled lockwashers (21) and windshield frame (5) from left (22) and right (24) upper hinges and cab (9). Discard screw-assembled lockwashers (21). Remove six screw-assembled lockwashers (18) and lower left hinge (17) from cab (9). Discard screw- assembled lockwashers (18). Remove six screw-assembled lockwashers (27) from lower right hinge (23) and cab (9). Discard screw-assembled lockwashers (27). Remove screw (26), lockwasher (25), and lower right hinge (23) from exhaust support (28) and cab (9). Discard lockwasher (25). Remove four screws (10) and two brackets (15) from windshield frame (5). Remove four screws (14), two plates (13), and weatherstrips (12) from two brackets (15). Discard weatherstrips (12). Remove weatherstrip (1) from windshield frame (5). Discard weatherstrip (1). Clean windshield frame (5) free of all weatherstrip (1) remains. 1. Remove knob (11) and stud (20) from upper left hinge (22). 2. Remove nut (19), hinge bolt (16), and upper left hinge (22) from lower left hinge (17). 11-30