TM 9-2320-361-20 11-18. GLOVE COMPARTMENT REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Adhesive (Appendix C, Item 2) EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). 1. Remove two screws (2) and bracket (3) from instrument panel (4). 2. Remove ten screws (9) and glove compartment (1) from instrument panel (4). 3. Remove four nuts (5), screws (7), and glove compartment door (6) from instrument panel (4). NOTE Perform step 4 if glove compartment door is damaged. 4. Inspect glove compartment door seal (8). If damaged, clean glove compartment door (6) seal mounting surface free of seal (8) debris. NOTE Perform steps 1 and 2 only if seal was removed. 1. Apply adhesive to glove compartment door (6) seal mounting surface and mounting side of seal (8). 2. Install seal (8) on glove compartment door (6). 3. Install bracket (3) on instrument panel (4) with two screws (2). 4. Install glove compartment door (6) on instrument panel (4) with four screws (7) and nuts (5). 5. Install glove compartment (1) on instrument panel (4) with ten screws (9). 11-28