TM 9-2320-361-20 11-15. HOOD HINGES REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS All MATERIALS/PARTS Eight locknuts PERSONNEL REQUIRED Two REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). Glove compartment removed (para. 11-18). GENERAL SAFETY INSTRUCTIONS Keep fingers clear when replacing hinge. WARNING Keep fingers clear of hood and cowling when replacing hinge. Failure to do so may result in injury to personnel. NOTE Assistant will help with step 1. 1. Remove four locknuts (7), reinforcement (8), and four screws (1) from hinge (9) and cowling (3). Discard locknuts (7). 2. Remove four locknuts (5), reinforcement (6), four screws (2), and hinge (9) from hood (4) and cowling (3). Discard locknuts (5). b. Installation 1. Install hinge (9) and reinforcement (6) to hood (4) with four screws (2) and new locknuts (5). NOTE Assistant will help with step 2. 2. Install hinge (9) and reinforcement (8) to cowling (3) with four screws (1) and new locknuts (7). FOLLOW-ON TASK: Install glove compartment (para. 11-18). 11-24