TM 9-2320-361-20 11-13. HOOD FASTENERS REPLACEMENT This task covers: a. Hood Holddown Fastener and Bracket Removal d. Hood Support Hook Installation b. Safety Latch Removal e. Safety Latch Installation c. Hood Support Hook Removal f. Hood Holddown Fastener and Bracket Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Eight locknuts EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). NOTE Hood holddown, companion seat fastner, fastener and windshield holddown fasteners are replaced basically the same. Some fasteners have additional hardware and reinforcements. This procedure covers the hood holddown fastener only. a. Hood Holddown Fastener and Bracket Removal 1. Unlatch fastener (15) from bracket (13). 2. Raise and secure hood (10). 3. Remove two locknuts (11), screws (16), and fastener (15) from brush guard (17) Discard locknuts (11). 4. Remove two locknuts (12), screws (14), and bracket (13) from hood (10). Discard locknuts (12). b. Safety Latch Removal Remove two locknuts (20), screws (18), and safety latch (19) from hood (10). Discard locknuts (20). I c. Hood Support Hook Removal 1. Lower hood (10). 2. Remove hook (7) from clip (9). 3. Remove screw (8) and clip (9) from cowling (1). 4. Remove locknut (3), washer (4), nut (6), and hook (7) from bolt (5). Discard locknut (3). 5. Remove locknut (2) and bolt (5) from cowling (1). Discard locknut (2). d. Hood Support Hook Installation 1. Install nut (6), bolt (5), washer (4), and new locknut (3) on hook (7). Install assembled hook (7) on cowling (1) with new locknut (2). 2. Install clip (9) on cowling (1) with screw (8). 3. Install hook (7) on clip (9). 11-20