TM 9-2320-361-20 11-6. CAB DOOR WINDOW REGULATOR AND HANDLE REPLACEMENT This task covers: a. Window Regulator Handle Removal c. Cab Door Window Regulator Installation b. Cab Door Window Regulator Removal d. Window Regulator Handle Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). REFERENCES (TM) Cab door glass removed (para. 11-5). TM 9-2320-361-10 TM 9-2320-361-20P a. Window Regulator Handle Removal Remove screw (6), window regulator handle (5), and washer (4) from cab door window regulator (7). b. Cab Door Window Regulator Removal NOTE Cab door window regulator must be supported as last screw is removed. 1. Remove four screws (3) from inner door panel (2) and cab door window regulator (7). 2. Slide regulator arm stud (8) out of stationary track (9) and remove cab door window regulator (7) through cab door (1) inspection hole. c. Cab Door Window Regulator Installation 1. Install window regulator (7) through cab door (1) inspection hole and slide regulator arm stud (8) into stationary track (9). NOTE Regulator arm stud must be held in stationary track when installing window regulator to inner door panel. 2. Install window regulator (7) on inner door panel (2) with four screws (3). d. Window Regulator Handle Installation Install washer (4) and window regulator handle (5) on window regulator (7) with screw (6). 11-8