TM 9-2320-361-20 11-5. CAB DOOR GIASS AND WEATHERSEAL REPLACEMENT This task covers: a. Removal c. Cab Door Glass Adjustment b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Two fasteners EQUIPMENT CONDITION Four lockwashers Parking brake set (TM 9-2320-361-10). Cab door inspection hole cover removed (para. 11-2). 1. Lower cab door glass (8) so regulator channels (2) are accessible through cab door (4) inspection hole. NOTE Mark position of regulator stop brackets for installation. 2. Remove four screws (7), lockwashers (6), and two window regulator stop brackets (5) from regulator channels (2), Discard lockwashers (6). 3. Remove two fasteners (1) from window regulator arm studs (3). Discard two fasteners (1). 4. Pull two regulator arm studs (3) out of two regulator channels (2) and slide cab door glass (8) out of cab door (4). 5. Remove weatherseal (10) from cab door (4). 6. Remove five clips (9) from weatherseal (10). 1. Install five clips (9) to weatherseal (10) and aline clips (9) with panel slots (11). 2. Install weatherseal (10) and clips (9) on cab door (4) so clips (9) snap into corresponding panel slots (11). 3. Slide cab door glass (8) into cab door (4) and install two window regulator arm studs (3) through two regulator channels (2). 4. Install two new fasteners (1) on window regulator arm studs (3). 5. Install two window regulator stop brackets (5) on regulator channels (2) with four new lock- washers (6) and screws (7). Do not tighten. c. Cab Door Glass Adjustment 1. Raise cab door glass (8) to full up position. 11-6