TM-9-2320-361-20 Page 693

TM-9-2320-361-20 Unit Maintenance Manual for M44A2 Series Trucks

Page 693 of 1207

TM 9-2320-361-20 10-8. BRUSH GUARD, STONE SHIELD, AND HEADLIGHT GUARD REPLACEMENT This task covers: a. Stone Shield Removal d. Headlight Guard Installation b. Brush Guard Removal e. Brush Guard Installation c. Headlight Guard Removal f. Stone Shield Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Twenty-three locknuts EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). a. Stone Shield Removal NOTE Radiator stone shield consists of an upper and lower stone shield. On vehicles with a front winch, a lower stone shield is not used. Some vehicles may have washers between brush guard and brush guard bracket. 1. Remove four locknuts (19), screws (10), two washers (15), and lower stone shield (9) from brush guard (4) and upper stone shield (7). Discard locknuts (19). 2. Remove three locknuts (5), screws (8), brackets (6), and upper stone shield (7) from brush guard (4). Discard locknuts (5). b. Brush Guard Removal 1. Loosen two locknuts (16) and screws (18) from brush guard (4) and frame rail brackets (17). Discard locknuts (16). 2. Remove four locknuts (1) and (22), four washers (21) and (14), screws (20) and (13), and brush guard (4) from angle brackets (3). Discard locknuts (1) and (22). NOTE On vehicles without front winch, there is an additional brush guard bracket. If vehicle is equipped with stone shield, proceed to step 4. 3. Remove two locknuts (19), screws (10), washers (15), and upper brush guard bracket (12) from brush guard (4). 4. Remove two locknuts (19), screws (10), washers (15), and lower brush guard bracket (11) from brush guard (4). Discard locknuts (19). c. Headlight Guard Removal NOTE This procedure can also be done with brush guard installed on vehicle. 1. Remove four locknuts (1), screws (20), and washers (21) from brush guard (4). Discard locknuts (1). 2. If brush guard (4) was not removed from vehicle, remove two locknuts (22), washers (14), screws (13), and headlight guard (2) from brush guard (4). Discard locknuts (22). 10-10