para. 9-11 TM 9-2320-361-20 9-9. STEERING GEAR ADJUSTMENT This task covers: Adjustment INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED Remove drag link from pitman arm (para. 9-11). Remove horn button (para. 4-30). Two REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P Adjustment NOTE Ensure all steering system components are tight. If any steering component is damaged, replace. If loose, tighten. 1. Hold screw (4) still, loosen nut (5), then loosen screw (4). 2. Turn steering wheel (2) all the way to the right, then all the way turns. 3. Turn steering wheel (2) right, half the number of turns counted. 4. Tighten screw (4) until it is slightly snug, and tighten nut (5). 5. Turn steering wheel (2) one turn each way around mid-position. NOTE Assistant will help with step 6. to the left, counting the number of 6. With steering wheel (2) at mid-position, hold screw (4) still, loosen nut (5), then tighten screw (4) until torque at nut (3) on steering column (1) reads 9-35 lb-in. (1.0 -4.0 NŽm). 7. Hold screw (4) still and tighten nut (5). Install horn button (para. 4-30). 9-15