TM 9-2320-361-20 9-7. TOE-IN CHECK AND ADJUSTMENT (Contd) NOTE If measurement is larger on front side of tires than measurement on rear side of tires, tires have toe-out. If toe-in alinement does not meet specifications, repeat checking procedures to eliminate any possible reading errors. 8. Subtract measurement from front side of tires (3) step 5, from measurement from rear side of tires (3) step 7. The result of this subtraction represents inches of toe-in. Proper toe-in is 0.13 in. ± 0.06 in. (3.2 mm+ 1.6 mm). b. Toe-In Adjustment 1. Loosen two nuts (7) at each end of tie rod (6). 2. Turn tie rod (6) in 1/2 turn increments and measure toe-in until toe-in of. 13 in. ±+ .06 in. (3.2 mm ± 1.6 mm) is obtained. 3. When correct toe-in is obtained, tighten two nuts (7)60 lb-ft (81 NŽm). 9-13