TM 9-2320-361-20 8-26. AIR COMPRESSOR AND PULLEY REPLACEMENT This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: APPLICABLE MODELS All MATERIALS/PARTS Three gaskets Eight lockwashers Antiseize tape (Appendix C, Item 27) Cap and plug set (Appendix C, Item 8) REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P EQUIPMENT CONDITION Air reservoir drained (TM 9-2320-361-10). Air compressor drivebelt removed (para. 8-28). GENERAL SAFETY INSTRUCTIONS Do not disconnect air lines before draining air reservoirs. Allow air compressor to cool before handling. a. Removal 1. 2. 3. 4. 5. 6. 7. 8. 9. WARNING Do not disconnect air lines before draining air reservoirs. Small parts under pressure may shoot out with high velocity, causing injury to personnel. Air compressor becomes hot during operation. Allow compressor to cool before handling, or injury to personnel may result. NOTE Plug air lines as they are disconnected. Remove air line (7) from adapter (4). NOTE On some air compressors, the air governor air line is on front of compressor near pulley. Remove air governor air line (2) from elbow (3). Remove screw (14), clamp (13), and fuel pump return line (1) from air compressor (10). Tie fuel pump return line (1) out of way. Install screw (14) in air compressor (10). Remove screw (5) and bracket (6) from air compressor (10). Install screw (5) in air compressor (10). Remove four nuts (8), lockwashers (9), and bracket (15) from base of air compressor (10). Discard lockwashers (9). Tie tachometer cable (16) and bracket (15) out of way. Remove air compressor (10) and gasket (11) from air compressor support (12). Discard gasket (11). 8-62