TM 9-2320-361-20 8-13. BRAKE PEDAL LEVER REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Cotter pin EQUIPMENT CONDITION Two woodruff keys Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED Remove hydraulic hoist pump propeller shaft (M342A2) (para. 12-14). Two Remove transmission PTO shift linkage (if so equipped) (para. 13-20). Remove hydraulic hoist control linkage (M342A2) (para. 13-22). a. Removal 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Unhook clutch return (1) from relay lever (2). Unhook brake pedal return spring (14) from clevis pin (8). Remove nut (19), washer (20), screw (3), and yoke rod (4) from relay lever (2). Remove screw (5) and nut (21) from relay lever (2). Remove relay lever (2) and woodruff key (18) from shaft (6). Discard woodruff key (18). Remove screw (22), clutch pedal rod (24), and bumper (23) from arm (28). Remove screw (27), clutch pedal arm (28), and woodruff key (26) from shaft (6). Discard woodruff key (26). Remove screw (12), washer (11), brake pedal lever (13), and bumper (10) from brake pedal rod (9). Remove brake pedal rod (9) from cab. Remove cotter pin (15), clevis pin (8), and yoke (16) from brake pedal lever (13). Discard cotter pin (15). NOTE Assistant will help with steps 10 and 11. On vehicles equipped with transmission power takeoff, pull shaft free of inside of bracket and brake pedal lever until lever can be removed. Remove shaft (6) through bracket (17) and brake pedal lever (13) until brake pedal lever (13) cab be removed from bracket (17). Remove shaft (6) from frame (25). Remove grease fitting (7) from brake pedal lever (13). b. Installation NOTE Assistant will help with step 1. When installing shaft make sure enough room is afforded for installation of relay lever and clutch pedal arm. 1. Position brake pedal lever (13) in bracket (17) and yoke (16), and install shaft (6) through frame (25), bracket (17), and brake pedal lever (13). 8-36