TM 9-2320-361-20 7-22. TORQUE RODS REPLACEMENT (Contd) 1. 2. 3. 4. 5. 6. 7. 7-52 Adjust jack under tandem axle bracket (4) until center of hole in axle bracket (6) is 7.00 ± 0.125 in. (17.78 ± 0.317 cm) from lower edge of frame (5). Install one end of upper torque rod (12) on bracket (3) with new lockwasher (16) and nut (15). Finger tighten nut (15). Install other end of upper torque rod (12) on axle bracket (6) with new lockwasher (7) and nut (8). Tighten nuts (8) and (15) 175-200 lb-ft (237-271 NŽm). Install brake line (11) on upper torque rod (12) with two new tiedown straps (14). Install spring saddle (1) on spring seat (13) with two U-bolts (2), four new lockwashers (9), and nuts (10). Tighten nuts (10) 190-220 lb-ft (258-298 NŽm). Install one end of torque rod (22) on bracket (23) with new lockwasher (17) and nut (18). Finger tighten nut (18). Install other end of torque rod (22) on axle bracket (19) with new lockwasher (20) and nut (21). Tighten nuts (18) and (21) 175-200 lb-ft (237-271 NŽm).