TM 9-2320-361-20 Section Ill. FRONT AND REAR SUSPENSION MAINTENANCE I 7-12. FRONT AND REAR SUSPENSION MAINTENANCE INDEX 1 PARA. TITLE PAGE NO. NO. 7-13. 7-14. 7-15. 7-16. 7-17. 7-18. 7-19. 7-20. 7-21. 7-22. Front Spring Replacement Front Spring Shackle Replacement Front Spring Bumper Replacement Front Spring Maintenance Rear Spring Replacement Rear Spring Maintenance Rear Spring Seat Replacement Shock Absorber Replacement Rear Spring Wear Pad Replacement Torque Rods Replacement 7-28 7-32 7-34 7-36 7-40 7-42 7-44 7-46 7-48 7-50 I 7-13. FRONT SPRING REPLACEMENT I This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All LO 9-2320-209-12-1 MATERIALS/PARTS TM 9-2320-361-10 TM 9-2320-361-20P Four locknuts Four lockwashers EQUIPMENT CONDITION Adhesive sealant (Appendix C, Item 5) ● Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED ● Front right wheel removed (para. 9-2). Two a. Removal NOTE Left and right front springs are replaced the same way. This procedure covers the right side. 1. Raise front of vehicle and remove two jack stands (11) from under front axle (12). 2. Support vehicle at frame (26) with two jack stands (11). 3. Place hydraulic jack (14) under front axle (12). 4. Remove jamnut (18), nut (19), retainer (20), and rubber bushing (21) from shock absorber piston rod (25). 5. Push shock absorber piston rod (25) up and out of plate (15). 6. Remove rubber bushing (23) and retainer (24) from piston rod (25). 7-28