TM 9-2320-361-20 7-6. FRONT AXLE SHAFT AND UNIVERSAL JOINT MAINTENANCE (Contd) c. Installation 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 7-18 Lubricate U-joint (5) (LO 9-2320-209-12-1). Coat splines (3) and (6) with GO 80/90 oil. Install thick thrust washer (7) on shaft (10) with tapered side of thrust washer (7) toward U-joint (5). Carefully slide axle shaft (10) into axle housing (9) and seat splines (6) in differential. Install thin thrust washer (2) on shaft (4) with tapered side of thrust washer (2) toward U-joint (5). Run l/8 in. x l/8 in. (3.2 mm x 3.2 mm) bead of sealing compound on inside surface of deflector (15) just inside of stud circle. Apply sealing compound on studs (14). Install spindle (1) on shaft (4) and seat on studs (14) of knuckle (8). Install brake plate (13) and deflector (15) on spindle (1) and studs (14) of knuckle (8) with twelve new lockwashers (16) and nuts (17). Tighten nuts (17) 25-35 lb-ft (34-48 NŽm). Install spring, (11) on brakeshoe (12). Install hose connector (19) on back of wheel cylinder (18) with two new washers (21) and screw (20).