TM 9-2320-361-20 7-3. INTERMEDIATE PROPELLER SHAFT MAINTENANCE (M36A2) This task covers: a. Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) M36A2 LO 9-2320-209-12-1 MATERIALS/PARTS TM 9-214 TM 9-2320-361-20P Two seals Ten locknuts EQUIPMENT CONDITION Cotter pin Forward-rear axle propeller shaft removed Lockwasher (para. 7-2). GAA grease (Appendix C, Item 13) Drycleaning solvent (Appendix C, Item 26) GENERAL SAFETY INSTRUCTIONS Rags (Appendix C, Item 21) Keep fire extinguisher nearby when using drycleaning solvent. PERSONNEL REQUIRED Two 1. 2. 3. 4. Remove cotter pin (8), nut (9), washer (10), flange (11), and deflector (12) from shaft (23). Discard cotter pin (8). NOTE Assistant will help with step 2. Remove two locknuts (16), washers (15), screws (7), propeller shaft (23), and bearing housing (18) from frame support (4). Discard locknuts (16). NOTE Mark yoke position for installation. Remove four locknuts (25) and flange yoke (24) from flange (26) and studs (1) located in parking brakedrum (2). Discard locknuts (25). Remove four locknuts (3) locknuts (3). b. Disassembly 1. Remove bearing housing screws (5), and frame support (4) from crossmember (6). Discard 18) from propeller shaft (23). 2. Remove screw (22), lockwasher (21), and side shield (20) from propeller shaft (23). Discard lockwasher (21). 3. Remove two seals (13) and bearing (19) from bearing housing (18). Discard seals (13). 4. Remove four rubber insulators (14) from bearing housing (18). NOTE Perform step 5 if lubrication fitting is damaged. 5. Remove lubrication fitting (17) from bearing housing (18). 7-6