TM 9-2320-361-20 4-52. CAB PROTECTOR WIRING HARNESS REPLACEMENT (M756A2) This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) M756A2 TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Two locknuts EQUIPMENT CONDITION Lockwasher Parking brake set (TM 9-2320-361-10). Safety wire (Appendix C, Item 22) Battery ground cable disconnected (para. 4-48). CAUTION Use care when removing or routing harness. Snagging may result, and forceful pulling will cause damage to harness. NOTE Tag all leads for installation. 1. 2. 3. 4. 5. Disconnect cab protector wiring harness (2) from two floodlights (5), three clearance light wires (4), and rear wiring harness (11). Remove four grommets (3) from cab protector (1) and cab protector wiring harness (2). Remove locknut (7), screw (16), and clamp (6) from cab protector wiring harness (2) and rear winch support (8). Discard locknut (7). Remove locknut (10), screw (13), lockwasher (14), ground terminal (12), and clamp (15) from crossmember (9) and cab protector wiring harness (2). Discard locknut (10) and lockwasher (14). Remove cab protector wiring harness (2) from cab protector (1). b. Installation 1. Install cab protector wiring harness (2) in cab protector (1). 2. Install four grommets (3) on cab protector wiring harness (2) and cab protector (1). 3. Install clamp (15), ground terminal (12), and cab protector wiring harness (2) on crossmember (9) with new lockwasher (14), screw (13), and new locknut (10). 4. Install clamp (6) on cab protector wiring harness (2) and rear winch support (8) with screw (16) and new locknut (7). 5. Connect cab protector wiring harness (2) to rear wiring harness (11), three clearance light wires (4), and two floodlights (5). 4-82