TM 9-2320-361-20 4-48. BATTERY CABLES AND CLAMPS REPLACEMENT (Contd) c. Ground Cable Removal 1. Remove nut (24), screw (34), and disconnect ground cable (26) from battery clamp (25). 2. Remove nut (18), lockwasher (19), ground cable (26), lockwasher (22), and screw (21) from frame (20). Discard lockwashers (19) and (22). d. Battery-to-Battery Cable Removal 1. Remove nut (30), screw (2), and cable (1) from negative clamp (4). 2. Remove nut (32), screw (29), and cable (1) from positive clamp (27). e. Positive Cable Removal 1. Remove nut (7), screw (10), and disconnect positive cable (5) from battery clamp (6). NOTE Remove two wires from starter solenoid on M756A2 model. 2. Remove nut (40) and disconnect positive cable (5) and wire (39) from starter solenoid (38). 3. Remove screw (36), clamp (37), and positive cable (5) from frame (20). f. Battery Clamps Removal 1. Remove two nuts (31) and (23), screws (3) and (35), and clamps (4) and (25) from two negative posts (15). 2. Remove two nuts (8) and (33), screws (11) and (28), and clamps (6) and (27) from two positive posts (12). g. Battery Clamps Installation 1. Install two clamps (6) and (27) on two positive posts (12) with two screws (11) and (28) and nuts (8) and (33). 2. Install two clamps (4) and (25) on two negative posts (15) with two screws (3) and (35) and nuts (31) and (23). h. Positive Cable Installation 1. Install clamp (37) and positive cable (5) on frame (20) with screw (36). NOTE Install two wires on starter solenoid for M756A2 model. 2. Connect wire (39) and positive cable (5) to starter solenoid (38) with nut (40). 3. Connect positive cable (5) to clamp (6) with screw (10) and nut (7). i. Battery-to-Battery Cable Installation 1. Install cable (1) on positive clamp (27) with screw (29) and nut (32). 2. Install cable (1) on negative clamp (4) with screw (2) and nut (30). j. Ground Cable Installation 1. Connect ground cable (26) to frame (20) with new lockwasher (22), screw (21), lockwasher (19), and nut (18). 2. Connect ground cable (26) to battery clamp (25) with screw (34) and nut (24). 3. Push battery box (13) into battery compartment (17) and install with two clamps (16) and thumbscrews (14). 4. Close battery compartment door (9). 4-74