TM 9-2320-361-20 4-46. REAR COMPOSITE LAMPS AND HOUSING REPLACEMENT This task covers: a. Rear Composite Lamps Removal c. Rear Composite Lamps Housing Installation b. Rear Composite Lamps Housing Removal d. Rear Composite Lamps Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Two lockwashers EQUIPMENT CONDITION Gasket Parking brake set (TM 9-2320-361-10). Battery ground cable disconnected (para. 4-48). a. Rear Composite Lamps Removal 1. Loosen six screws (8) and remove lens (9) and gasket (7) from composite lamp housing (5). Discard gasket (7). 2. Remove lamp(s) (6) from composite lamp housing (5). b. Rear Composite Lamps Housing Removal I NOTE Tag all wires for installation. 1. Disconnect four wires (10) from wires (4). 2. Remove two screws (1), lockwashers (2), and lockwashers (2). c. Rear Composite Lamps Housing Installation composite lamp housing (5) from bracket (3). Discard 1. Install composite lamp housing (5) on bracket (3) with two new lockwashers (2) and screws (1). 2. Connect four wires (10) to wires (4). d. Rear Composite Lamps Installation 1. Install lamp(s) (6) in composite lamp housing (5). 2. Install new gasket (7) and lens (9) on composite lamp housing (5) with six screws (8). 4-70