para. 4-48 TM 9-2320-361-10 TM 9-2320-361-20 4-45. SIDE MARKER AND CLEARANCE LAMPS REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Six lockwashers EQUIPMENT CONDITION Locknut Parking brake set (TM 9-2320-361-10). Battery ground cable disconnected (para. 4-48). NOTE All side marker lights and clearance lights are replaced the same. 1. Remove two screws (11), lens frame (10), and lens (9) from marker light base (6). 2. Remove lamp (8) from marker light base (6). 3. Remove four nuts (3), lockwashers (4), and screws (7) from marker light base (6) and bracket (5). Discard lockwashers (4). 4. Disconnect wire (2) from wire (1) and remove marker light base (6) from bracket (5). 5. Remove locknut (13), two lockwashers (14), screw (15), and bracket (5) from fender (12). Discard lockwashers (14) and locknut (13). b. Installation 1. Install bracket (5) on fender (12) with screw (15), two new lockwashers (14), and new locknut (13). 2. Connect wire (2) to wire (1). 3. Install marker light base (6) on bracket (5) with four screws (7), new lockwashers (4), and nuts (3). 4. Install lamp (8) in marker light base (6). 5. Install lens (9) and lens frame (10) on marker light base (6) with two screws (11). 4-69