TM 9-2320-361-20 4-40. INTERMEDIATE TURN SIGNAL REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS All REFERENCES (TM) TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Three lockwashers EQUIPMENT CONDITION Two O-rings Parking brake set (TM 9-2320-361-10). Battery ground cable disconnected (para. 4-48). a. Removal 1. Remove amber lens (4), red lens (1), two O-rings (2), and lamp (3) from bracket (14). Discard O-rings (8). 2. Disconnect wire (13) from connector (12). 3. Remove nut (5), lockwasher (6), washer (15), and bracket (14) from brush guard (7). Discard lockwasher (6). 4. Remove two screws (11), lockwashers (10), nuts (9), and brush guard (7) from bracket (8). Discard lockwashers (10). 1. Install brush guard (7) on bracket (8) with two screws (11), new lockwashers (10), and nuts (9). 2. Install bracket (14), washer (15), new lockwasher (6), and nut (5) on brush guard (7). 3. Connect wire (13) to connector (12). 4. Install lamp (3), two new O-rings (2), red lens (1), and amber lens (4) on bracket (14). FOLLOW-ON TASKS: Connect battery ground cable (para. 4-48). Check operation of intermediate turn signal ight (TM 9-2320-361-10). 4-61