TM 9-2320-361-20 4-20. TURN SIGNAL FLASHER REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Four lockwashers EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). Battery ground cable disconnected (para. 4-48). 1. Disconnect cable connector (4) from turn signal flasher (10). 2. Remove nut (1), lockwasher (2), ground wire (3), screw (7), and lockwasher (6) from turn signal flasher (10). Discard lockwashers (2) and (6). 3. Remove nut (12), lockwasher (11), screw (9), lockwasher (8), and turn signal flasher (10) from left front fender (5). Discard lockwashers (11) and (8). b. Installation 1. Install turn signal flasher (10) on left front fender (5) with screw (9), two new lockwashers (8) and (11), and nut (12). 2. Install screw (7), new lockwasher (6), ground wire (3), new lockwasher (2), and nut (1). 3. Connect cable connector (4) to turn signal flasher (10). FOLLOW-ON TASKS: Connect battery ground cable (para. 4-48). Operate turn signal control to check turn signal flasher (TM 9-2320-361-10). 4-35