TM 9-2320-361-20 4-17. HEADLIGHT HIGH BEAM INDICATOR AND LAMP REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS All MATERIALS/PARTS Two lockwashers REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). NOTE Headlight high beam indicator assembly and the two instrument cluster light assemblies are removed and installed the same. This procedure covers the high beam indicator light. 1. Turn lens (2) to left and remove. 2. Push in and turn lamp (3) to left and remove. 3. Remove two screws (4), lockwashers (5), and headlight high beam indicator (6) from instrument cluster (1). Discard lockwashers (5). 4. Disconnect connector (7) from headlight high beam indicator (6). 1. Connect connector (7) to headlight high beam indicator (6). 2. Install headlight high beam indicator (6) in instrument cluster (1) with two new lockwashers (5) and screws (4). 3. Install lamp (3) on high beam indicator (6). 4. Install lens (2) over lamp (3). 4-32