TM 9-2320-361-20 4-10. INSTRUMENT CLUSTER REPLACEMENT (Contd) b. Disassembly 1. Remove two indicator panel lamps (8) (para. 4-17). 2. Remove high beam indicator (15) (para. 4-17). 3. Remove tachometer (6) (para. 4-13). 4. Remove speedometer (7) (para. 4-13). 5. Remove oil pressure gage (9), engine temperature gage (4), battery and generator gage (24), and fuel gage (21) (para. 4-12). 6. Remove air pressure gage (27) (para. 4-11). 1. Install air pressure gage (27) (para. 4-11). 2. Install fuel gage (21), battery and generator gage (24), engine temperature gage (4), and oil pressure gage (9) (para. 4-12). 3. Install speedometer (7) (para. 4-13). 4. Install tachometer (6) (para. 4-13). 5. Install high beam indicator (15) (para. 4-17). 6. Install two indicator panel lamps (8) (para. 4-17). d. Installation 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Connect wire plug (22) to battery and generator gage (24). Connect wire connectors (13) and (23) to both panel lamps (8). Connect wire connector (14) to high beam indicator (15). Connect wire plugs (20) and (18) to fuel gage (21). Connect wire plugs (10) and (11) to oil pressure gage (9). Connect wire plugs (5) and (25) to engine temperature gage (4). Connect wire plug (16) to wire connector (17). Wrap threads of air pressure gage (27) with antiseize tape and connect air line (26). Connect speedometer drive shaft (12) to speedometer (7). Connect tachometer drive shaft (19) to tachometer (6). Position instrument cluster (2) to instrument panel (3) and install by turning four lockstuds (1) 1/4 turn to right. 4-18