TM 9-2320-361-20 4-8. STARTER SWITCH REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS All REFERENCES (TM) TM 9-2320-361-10 MATERIALS/PARTS Lockwasher TM 9-2320-361-20P EQUIPMENT CONDITION ● Parking brake set (TM 9-2320-361-10). ● Battery ground cable disconnected (para. 4-48). NOTE Starter switch may be located to the right of the steering column on older models. 1. Remove nut (3) from engine starter switch (5). 2. Remove lockwasher (2), plate (l), and starter switch (5) from instrument panel (7). Discard lockwasher (2). 3. Disconnect plug (6) from starter switch (5). 4. Remove adjusting nut (4) from starter switch (5). b. Installation 1. Install nut (4) on starter switch (5). 2. Connect plug (6) to starter switch (5). 3. Install starter switch (5) and plate (1) on instrument panel (7) with new lockwasher (2) and nut (3). FOLLOW-ON TASKS: Connect battery ground cable (para. 4-48). ● Start engine (TM 9-2320-361-10). 4-14