TM 9-2320-361-20 Section Il. STARTING SYSTEM MAINTENANCE 4-5. STARTING SYSTEM MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 4-6. Magnetic Starter Relay and Mounting 4-10 Bracket Replacement 4-7. Starter Motor Replacement 4-12 4-8. Starter Switch Replacement 4-14 4-6. MAGNETIC STARTER RELAY AND MOUNTING BRACKET REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Two locknuts EQUIPMENT CONDITION Six lockwashers Ž Parking brake set (TM 9-2320-361-10). ● Hood raised and secured (TM 9-2320-361-10). ● Battery ground cable disconnected (para. 4-48). ● Air cleaner assembly removed (para. 3-15). NOTE Tag leads for installation. 1. Remove nut (1), washer (2), and cable (3) from magnetic starter relay (19). 2. Remove nut (9), washer (8), and cables (7) and (6) from magnetic starter relay (19). 3. Remove nut (16), washer (17), and cable (18) from magnetic starter relay (19). 4. Remove two locknuts (4), lockwashers (5), screws (15), and magnetic starter relay (19) from mounting bracket (10). Discard two locknuts (4) and lockwashers (5). 5. Remove two screws (14), lockwashers (13) and (12), and mounting bracket (10) from engine block (11). Discard lockwashers (13) and (12). 1. Install mounting bracket (10) on engine block (11) with two screws (14) and new lockwashers (13) and (12). 2. Install magnetic starter relay (19) on mounting bracket (10) with two screws (15), new lock- washers (5), and locknuts (4). 3. Install cable (3) on relay (19) with washer (2) and nut (1). 4. Install cables (6) and (7) on relay (19) with washer (8) and nut (9). 5. Install cable (18) on relay (19) with washer (17) and nut (16). 4-10