TM 9-2320-361-20 3-45. WATER MANIFOLD AND HOSE REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Six lockwashers EQUIPMENT CONDITION Three gaskets ● Parking brake set (TM 9-2320-361-10). • Hood raised and secured (TM 9-2320-361-10). ● Manifold heater removed (uncovered) (para. 3-31). NOTE There are two water manifolds and hoses. Both are removed the same way. 1. Loosen two clamps (7) on hose (8). 2. Remove six screws (1) and lockwashers (2) from water manifold (3). Discard lockwashers (2). 3. Remove water manifold (3), three gaskets (4), hose (8), and two clamps (7) from cylinder head (6) and intake manifold (5). Discard gaskets (4). 1. Install hose (8) and two clamps (7) on water manifold (3). Do not tighten clamps (7). 2. Install three new gaskets (4) and water manifold (3) on cylinder head (6) and intake manifold (5) with six new lockwashers (2) and screws (l). 3. Tighten two clamps (7) on hose (8). FOLLOW-ON TASK: Install manifold heater (uncovered) (para. 3-31). 3-103