TM 9-2320-361-20 3-42. RADIATOR AND BRACKETS REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Ten locknuts EQUIPMENT CONDITION Lockwasher Antifreeze (Appendix C, Item 6) Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). PERSONNEL REQUIRED Upper and lower radiator hose removed (para. 3-43). Two Brushguard removed (para. 10-8). Fan removed (para. 3-40). 1. Remove locknut (8), washer (9), ground strap (10), lockwasher (11), and screw (1) from radiator (2). Discard locknut (8) and lockwasher (11). 2. Remove two locknuts (6), washers (5), springs (7), and washers (4) from radiator mounting studs (3). Discard locknuts (6). CAUTION Radiator core is easily damaged. Use care when working near or handling radiator. 3. Remove locknut (15), screw (12), and rod assembly (14) from bracket (13). Discard locknut (15). NOTE Assistant will help with step 4. 4. Tilt radiator (2) forward and carefully lift out of vehicle. NOTE Perform step 5 only if radiator and draincock are damaged or if radiator is being replaced. 5. Remove radiator cap (16) and draincock (17) from radiator (2). 6. Remove two shims (18) from radiator mounting studs (3). 7. Remove two locknuts (24), screws (22), and support (21) from left bracket (23) and right bracket (20). Discard locknuts (24). 8. Remove four locknuts (25), screws (19), left bracket (23), and right bracket (20) from radiator (2). Discard locknuts (25). 3-96