TM 9-2320-361-20 Section Vlll. EXHAUST SYSTEM MAINTENANCE 3-36. EXHAUST SYSTEM MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 3-37. Exhaust System Replacement 3-82 3-38. Exhaust System Replacement (M50A2 and M50A3) 3-86 3-37. EXHAUST SYSTEM REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All except M50A2, M50A3 Air cleaner element removed (para. 3-14). MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Four gaskets Do not touch hot exhaust system components with Ten locknuts bare hands. Two lockwashers REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P 1. 2. 3. 4. 5. 6. 7. 8. 3-82 WARNING Do not touch hot exhaust system components with bare hands. Severe injury to personnel will result. Remove locknut (13) and screw (7) from coupling (14). Discard locknut (13). Disconnect elbow (9) from flex tube (15), and remove coupling (14) and gasket (8) from elbow (9). Discard gasket (8). Loosen clamp (11) and remove elbow (9), clamp (11), and gasket (10) from turbocharger (12). Discard gasket (10). Remove locknut (22) and screw (21) from coupling (23), and remove flex tube (15), coupling (23), and gasket (24) from exhaust pipe (29). Discard gasket (24) and locknut (22). Remove locknut (2) and screw (38) from coupling (39). Discard locknut (2). Remove stack pipe (1), coupling (39), and gasket (40) from exhaust pipe (29). Discard gasket (40). Remove four locknuts (4), screws (37), two clamps (3), and exhaust shield (36) from exhaust pipe (29). Discard locknuts (4). Remove two locknuts (30), washers (31), screws (34), washers (33), and cover plates (18) from fender (32). Discard locknuts (30).