TM 9-2320-361-20 3-35. HAND THROTTLE CONTROL CABLE MAINTENANCE (Contd) b. Installation 1. Install control cable (3) through instrument panel (2) and install new lockwasher (5) and nut (6) on hand throttle control (4). 2. Position screw (8) on end of cable (3). Push cable (3) through hole in cab floor (7). 3. Position nut (9) on end of cable (3) and instill nut (9) on screw (8) and cab floor (7). Do not tighten nut (9). 4. Install control wire (13) through accelerator rod flange (12). 5. Install connector (11) and screw (10) on control wire (13). DO not tighten screw (10). c. Adjustment 1. 2. 3. 4. 5. 6. Push HAND THROTTLE control (4) all the way in. NOTE Assistant will help with step 2. Hold accelerator pedal (1) down. Position control cable (3) through floor (7) until distance between end of control cable (3) and accelerator rod flange (12) is approximately 0.5 in. (13 mm). Release accelerator pedal (1). NOTE Assistant will help with step 5. Tighten screw (8) and nut (9). Position connector (11) next to accelerator rod flange (12) and tighten screw (10) on control wire (13). Bend end of control wire (13) up. 3-80