TM 9-2320-361-20 3-35. HAND THROTTLE CONTROL CABLE MAINTENANCE This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: APPLICABLE MODELS All MATERIAL/PARTS Lockwasher PERSONNEL REQUIRED Two REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). 1. Straighten end of control wire (4) and remove screw (1), connector (2), and control wire (4) from accelerator rod flange (3). NOTE Assistant will help with step 2. 2, Remove nut (7) from screw (6) and slide nut (7) off end of control cable (8). 3. Pull control cable (8) up through hole in cab floor (5) and remove screw (6) from end of control cable (8). 4. Remove nut (12) and lockwasher (11) fron control cable (8). Discard lockwasher (11). 5. Pull hand throttle control (10) out from instrument panel (9). 3-78