TM 9-2320-361-20 Section VIl. ACCELERATOR SYSTEM MAINTENANCE 3-32. ACCELERATOR SYSTEM MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 3-33. Accelerator Pedal, Brackets, and Rod Maintenance 3-70 3-34. Engine Stop Control Cable Maintenance 3-76 3-35. Hand Throttle Control Cable Maintenance 3-78 3-33. ACCELERATOR PEDAL, BRACKETS, AND ROD MAINTENANCE This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Five locknuts EQUIPMENT CONDITION Seven cotter pins Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED Hood raised and secured (TM 9-2320-361-10). Two 1. Remove throttle return spring (10) from swivel (9) and throttle return clip (1). 2. Remove screw (3), washers (2), and throttle return clip (1) from steering gear housing (12). 3. Remove cotter pin (4) and pin (11) from swivel (9) and disconnect swivel (9) from pump lever (13). Discard cotter pin (4). 4. Loosen screw (5) and remove connector (6), screw (5), and control wire (7) from accelerator rod (8). 5. Remove locknut (19), ball joint (21), and accelerator rod (22) from lever (20). Discard locknut (19). 6. Remove cotter pin (18), washer (17), and connecting link (16) from lever (20). Discard cotter pin (18). 7. Remove two cotter pins (14), pin (15), and lever (20) from bracket (24). Discard cotter pins (14). NOTE Assistant will help with step 8. 8. Remove two locknut (25), screws (26), and bracket (24) from cab floor (23). Discard locknuts (25). 3-70