TM 9-2320-361-20 Section Ill. CLUTCH SYSTEM MAINTENANCE 3-9. CLUTCH SYSTEM MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 3-10. Clutch Control Linkage Maintenance 3-14 3-11. Pedal Shaft Support Replacement 3-19 3-10. CLUTCH CONTROL LINKAGE MAINTENANCE This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Four locknuts Two woodruff keys Chalk (Appendix C, Item 9) REFERENCES (TM) LO 9-2320-209-12-1 TM 9-2320-361-10 TM 9-2320-361-20P Hood raised and secured (TM 9-2320-361-10). Accelerator pedal, bracket, and rod removed (para. 3-33). Transmission power takeoff shift linkage removed (vehicles with transmission PTO only) (para. 13-20). Hydraulic master cylinder removed (para. 8-10). 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Remove clutch return spring (7) from clutch shaft lever (6) and frame (10). Mark shaft of clutch pedal (3) with chalk next to remote control lever (14). Remove screw (1), clutch pedal (3), and rubber bumper (2) from remote control lever (14). Remove locknut (13), screw (4), remote control lever (14), and woodruff key (12) from pedal lever shaft (11). Discard locknut (13) and woodruff key (12). Remove locknut (9), screw (5), and rod (8) from clutch shaft lever (6). Discard locknut (9). Remove locknut (26), screw (21), and remote control lever (20) with rod (8) from shaft (22). Discard locknut (26). NOTE Do not remove spring loaded pin from clevis. Pull pin (24) to one side of clevis (25) and remove remote control lever (20) from clevis (25). Loosen nut (23) and remove clevis (25) and nut (23) from rod (8). Remove locknut (18), screw (17), clutch shaft lever (6), and pedal lever shaft (11) from brake lever (19) and shaft support (16). Discard locknut (18). Remove woodruff key (15) from shaft (11). Discard woodruff key (15). 3-14