TM 9-2320-361-20 3-7. ENGINE OIL FILTER AND BODY MAINTENANCE This task covers: a. Draining Oil d. Cleaning and Inspection b. Oil Filter Removal e. Body Assembly c. Body Disassembly f. Oil Filter Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Hood raised and secured (TM 9-2320-361-10). Four gaskets GENERAL SAFETY INSTRUCTIONS Two cotter pins Do not drain oil when engine is hot. Two filter elements Keep fire extinguisher nearby when using Two spacers Drycleaning solvent (Appendix C, Item 26) Lubricating oil, OE/HDO 30 (Appendix C, Item 19) REFERENCES (TM) LO 9-2320-209-12-1 TM 9-2320-361-10 TM 9-2320-361-20P a. Draining Oil WARNING drycleaning solvent. Compressed air source will not exceed 30 psi (207 kPa). Eyeshields must be worn when cleaning with compressed air. Do not drain oil when engine is hot. Hot oil may cause injury to personnel. NOTE Have drainage container ready to catch oil. 1. Remove two drainplugs (3) and spacers (2) from engine oil pan (1), and allow oil to completely drain. Discard spacers (2). 2. Install two new spacers (2) and drainplugs (3) on engine oil pan (1). b. Oil Filter Removal NOTE Have drainage container ready to catch oil. 1. Remove pipe plug (6) from filter housing (7) and allow oil to drain, NOTE Both engine oil filter bodies are removed the same way. 2. Loosen center post (4) and remove body (5) and gasket (8) from filter housing (7). Discard gasket (8). 3. Install pipe plug (6) on filter housing (7). 3-10