TM 9-2320-361-20 3-3. ENGINE REAR MOUNT PAD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Locknut Do not put fingers between frame and engine REFERENCES (TM) support. TM 9-2320-361-10 TM 9-2320-361-20P a. Removal NOTE Perform step 1 for engine left rear mount. 1. Remove nut (1) and accelerator linkage (3) from throttle control lever (2). NOTE Right and left engine rear mounts are removed the same way. This procedure covers the right engine rear mount. 2. Remove locknut (10), washer (9), and lower rear engine pad (8) from frame (7). Discard locknut (10). 3. Position hydraulic jack (13) and wood blocks (14) under transmission (12) lifting point. Raise transmission (12) just enough to take weight off upper rear engine pad (11). WARNING Do not put fingers between frame and engine support. Jack failure may cause injury to personnel. 4. Remove screw (4), washer (5), and upper rear engine pad (11) from frame (7) and engine support (6). 1. Install upper rear engine pad (11) on frame (7) with washer (5) and screw (4). 2. Lower hydraulic jack (13) and remove jack (13) and wood blocks (14) from transmission (12). 3. Install lower rear engine pad (8) on frame (7) with washer (9) and new locknut (10). Tighten locknut (10) 65-70 lb-ft (88-95 N·m). NOTE Perform step 4 for engine left rear mount. 4. Install accelerator linkage (3) on throttle control lever (2) with nut (1). 3-4