TM 9-2320-361-20 14-52. 100-AMP ALTERNATOR REGULATOR REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Eight lockwashers EQUIPMENT CONDITION Four locknuts Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED Hood raised and secured (TM 9-2320-361-10). Battery ground cable disconnected (para. 4-48). Two 1. Diconnect cable (13) and harness (12) from regulator (11). 2. Remove four nuts (10), lockwashers (9), and regulator (11) from two mounts (3). Discard lockwashers (9). 3. Remove four screws (2), lockwashers (1), and two brackets (8) from regualtor (11). Discard lockwashers (1). Assistant will help with step 4. 4. Remove four locknuts (6), washers (5), screws (7), and two mounts (3) from firewall (4). Discard locknuts (6). b. Installation NOTE Assistant will help with step 1. 1. Install two mounts (3) on firewall (4) with four screws (7), washers (5), and new locknuts (6). 2. Install two brackets (8) on regulator (11) with four new lockwashers (1) and screws (2). 3. Install regulator (11) on two mounts (3) with four new lockwashers (9) and nuts (10). 4. Connect cable (13) and harness (12) to regulator (11). 14-90