TM 9-2320-361-20 Section V. MOUNTING KIT MAINTENANCE 14-42. MOUNTING KITS MAINTENANCE INDEX PARA. TITLE PAGE NO. NO. 14-43. Machine Gun Mount Kit Replacement 14-70 14-44. Rifle Mounting Kit Replacement 14-75 14-45. Decontamination Mounting Kit Replacement 14-76 14-46. Chemical Agent Alarm Mounting Kit Replacement 14-78 14-47. Fire Extinguisher Mounting Kit Replacement 14-82 14-48. Bumper Step Kit Replacement 14-84 14-43. MACHINE GUN MOUNT KIT REPLACEMENT This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: APPLICABLE MODELS All EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Cab top removed, hardtop (para. 14-14), or soft top Thirty-two locknuts (TM 9-2320-361-10) (task d. only). Two cotter pins GENERAL SAFETY INSTRUCTIONS PERSONNEL REQUIRED Bracket posts must be held in position before Two removing U-bolts. REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P Clamp down latch on ring mount to prevent rotation during removal. 1. Remove twelve locknuts (5), screws (2), and twenty-four washers (3) from ring mount (1), adapter (4), front bracket post (6), and rear bracket posts (7) and (8). Discard locknuts (5). NOTE Assistant will help with steps 2 through 4. 2. Remove ring mount (1) from front bracket post (6), rear bracket posts (7) and (8), and adapter (4). 3. Loosen four screws (13) and remove front bracket post (6) from front gun mount bracket (11). Retighten four screws (13). WARNING Bracket posts must be held in position before removing U-bolts. Failure to do so may cause injury to personnel. 4. Remove eight locknuts (10), four U-bolts (9) and two rear bracket posts (7) and (8) from two rear gun mount brackets (12). Discard locknuts (10). 14-70