TM 9-2320-361-20 Section Ill. DEEP WATER FORDING KIT MAINTENANCE 14-37. DEEP WATER FORDING KIT MAINTENANCE INDEX PARA. NO. TITLE PAGE NO. 14-38. Air Intake Tubes Replacement 14-60 14-39. Control Valve Replacement 14-62 14-40. Regulator Valve Replacement 14-64 14-38. AIR INTAKE TUBES REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS Eight locknuts Tiedown strap TM 9-2320-361-20P EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). Hood raised and secured (TM 9-2320-361-10). a. Removal 1. Loosen clamp (18) and remove air tube (19) from air cleaner (2). 2. Loosen three clamps (14) and remove hose (15), elbow (16), and hose (17) from crankcase breather tube (13). 3. Loosen clamp (9) and remove hood (7) and sleeve (8) from air tube (19). 4. Remove four locknuts (12), screws (20), two retaining clamps (11), air tube (19), and hose (17) from supports (10). Discard locknuts (12). 5. Remove four locknuts (22), two supports (10), U-bolt (23), and clamp half (24) from exhaust pipe (21). Discard locknuts (22). 6. Remove tiedown strap (4), loosen two clamps (3), and remove hose (6) from air compressor (1), steering column (5), and air cleaner (2). Discard tiedown strap (4). 1. 2. 3. 4. 5. 6. 7. Install hose (6) on air cleaner (2) and air compressor (1). Tighten two clamps (3). Install hose (6) on steering column (5) with new tiedown strap (4). Install two supports (10) on exhaust pipe (21) with U-bolt (23), clamp half (24), and four new locknuts (22). Install hose (17), air tube (19), and two retaining clamps (11) on supports (10) with four screws (20) and new locknuts (12). Install hose (17), elbow (16), and hose (15) on crankcase breather tube (13). Tighten three clamps (14). Install air tube (19) through right side panel and on air cleaner (1) with clamp (18). Install sleeve (8) and hood (7) on air tube (19). Tighten clamp (9). 14-60