TM 9-2320-361-20 14-15. ALCOHOL EVAPORATOR REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Hood raised and secured (TM 9-2320-361-10). Three locknuts GENERAL SAFETY INSTRUCTIONS REFERENCES (TM) Diesel fuel is flammable. Do not perform this TM 9-2320-361-10 procedure near open flames. TM 9-2320-361-20P WARNING Do not perform this procedure while smoking or within 50 feet of sparks or open flame. Fuel is flammable and can explode easily, causing injury or death to personnel and damage to equipment. 1. Remove jar (9) and O-ring (8) from evaporator body (7). 2. Disconnect tube (5) from compressor elbow (13) and adapter (6). 3. Remove three locknuts (11), screws (12), and evaporator body (7) from bracket (1). Discard locknuts (11). 4. Disconnect adapter (6) from evaporator body (7). 5. Disconnect tube (3) from outlet manifold (2). 6. Remove two screws (4), outlet manifold (2), and bracket (1) from compressor (10). 1. Install bracket (1) and outlet manifold (2) on compressor (10) with two screws (4). 2. Connect tube (3) to outlet manifold (2). 3. Install adapter (6) on evaporator body (7). 4. Install evaporator body (7) on bracket (1) with three screws (12) and new locknuts (11). 5. Connect tube (5) to compressor elbow (13) and adapter (6). 6. Install O-ring (8) and jar (9) on evaporator body (7). 14-22