TM 9-2320-361-20 14-14. HARDTOP MAINTENANCE (Contd) d. Installation 1. 2. 3. 4. 5. 6. 7. 8. 9. NOTE Do not tighten any screws or nuts until kit is fully installed. Install seal (17) to back panel (8) with two retainers (18) and screws (19). Install back panel (8) to cab (14) and aline holes. Install fourteen washers (16), screws (15), and new locknuts (20) on back panel (8) and cab (14) NOTE Assistant will help with step 4. Place seal (7) on back panel (8). Install roof (3) on back panel (8) and aline holes. Install fourteen washers (6), screws (10), washers (9), and new locknuts (5) on back panel (8) and roof (3). Do not tighten. Install washer (12), capscrew (11), and new locknut (4) on each side of roof (3) and windshield frame (13). Close cab windows and inspect all panels for alinement and seating. Adjust panels as required. Tighten capscrews (11) and fourteen screws (10). Install two screws (1) and new lockwashers (2) on roof (3) and windshield frame (13). 14-21