TM 9-2320-361-20 14-14. HARDTOP MAINTENANCE This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All TM 9-2320-361-10 MATERIALS/PARTS TM 9-2320-361-20P Ten lockwashers EQUIPMENT CONDITION Thirty locknuts Parking brake set (TM 9-2320-361-10). PERSONNEL REQUIRED Two a. Removal 1. Remove two screws (1) and lockwashers (2) from each side of roof (3) and windshield frame (13). Discard two lockwashers (2). 2. Remove capscrew (11), washer (12), and locknut (4) from each side of roof (3) and windshield frame (13). Discard locknut (4). 3. Remove fourteen screws (10), locknuts (5), and washers (6) and (9) from roof (3). Discard locknuts (5). NOTE Assistant will help with step 4. 4. Remove roof (3) and seal (7). 5. Remove two screws (19) and retainers (18) from back panel (8). 6. Remove fourteen locknuts (20), screws (15), and washers (16) from back panel (8) and cab (14). Discard locknuts (20). 7. Remove back panel (8) and seal (17) from cab (14). b. Disassembly 1. Remove eight nuts (21), lockwashers (22), screws (25), and frame cap (24) from back panel (8). Discard lockwashers (22). 2. Remove fourteen nuts (28), washers (27), screws (26), and rear window (23) from back panel (8). 1. Install rear window (23) on back panel (8) with fourteen screws (26), washers (27), and nuts (28). 2. Install frame cap (24) on rear window (23) and back panel (8) with eight screws (25), new lock- washers (22), and nuts (21). 14-20