TM 9-2320-361-20 14-10. THERMAL BARRIER INSULATION REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS Driver’s seat removed (para. 11-28). Companion seat removed (para. 11-26). Adhesive sealant (Appendix C, Item 4) Methylethylketone (Appendix C, Item 16) REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P NOTE All thermal barrier insulation is removed the same way. This procedure covers replacement of left rear insulation panel only. 1. Pull panel (2) away from cab interior (1). Discard panel (2) if irreparable damage occurs when removing. 2. Clean all remaining insulating material and adhesive from contact surface areas. b. Installation 1. 2. 3. 4. 5. CAUTION Once panel is coated with methylethylketone and put in place, it cannot be moved. Be careful not to place panel in the wrong position. NOTE Make all necessary cutouts and slits in panels before installation. Shiny side of panel must face outward. Place panel (2) on cab (1) to check for fit. Remove panel (2) and coat contact areas with methylethylketone. Install panel (2) on cab (1) and press firmly into place. NOTE If additional adhesive sealant is required, perform steps 4 and 5. Remove panel (2) and coat contact areas with adhesive sealant. Install panel (2) on cab (1) and press firmly into place. 14-14