TM 9-2320-361-20 14-7. OIL PAN SHROUD AND EXHAUST TUBE REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS All EQUIPMENT CONDITION Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Three cotter pins Do not touch hot exhaust system components with Four lockwashers bare hands. Locknut REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P a. Removal WARNING Do not touch hot exhaust system components with bare hands; injury to personnel will result. 1. Remove cotter pin (9) and exhaust tube (10) from oil pan shroud (6). Discard cotter pin (9). 2. Remove two cotter pins (12), elbow (13), and exhaust tube (10) from heater (14). Discard cotter pins (12). 3. Remove locknut (1), screw (3), clamp (2), and exhaust tube (10) from splash shield (4). Discard locknut(1). 4. Remove exhaust tube (10) from vehicle. 5. Remove four screws (8), lockwashers (7), and oil pan shroud (6) from engine oil pan (5). Discard lockwashers (7). b. Installation 1. 2. 3. 4. 5. Install oil pan shroud (6) on engine oil pan (5) with four new lockwashers (7) and screws (8). Install exhaust tube (10) on oil pan shroud (6) with new cotter pin (9). Insert exhaust tube (10) through hole (11) in toolbox. Install elbow (13) and exhaust tube (10) on heater (14) with two new cotter pins (12). Install exhaust tube (10) on splash shield (4) with clamp (2), screw (3), and new locknut (1). 14-9